iPhone 13 mannequins have been sent to various companies that need them (usually, these are the case manufacturers), which has resulted in inevitable leaks. We have already seen a photo that represented the four models, now there are even more to see.
Here is a photo shared by Marques Brownlee. This time, the four models are shown in white. And no, the vanilla iPhone 13 is no bigger than the 13 Pro, it’s just slightly offset. Both models will continue to have the same size, even if they do not have the same screen.
Mannequins Apple iPhone 13
Current expectations are that only the two Pro models will have LTPO panels with a refresh rate of 120 Hz, while the other two phones will remain at 60 Hz. It is only at the generation of the iPhone 14 that Apple will bet on the LTPO.
Here are some cases that have already been produced. These adapt to current iPhone 12 models, however, the cameras and buttons don’t align quite properly.
iPhone 13 cases put on iPhone 12 – note the cameras and buttons misaligned
And check them out – they were shared by Benks, an accessory manufacturer in China. These will probably be used to make molds for the iPhone 13 cases.
Blanks used to create molds for iPhone 13 shells
The iPhone 13 series will be manufactured by Foxconn and Pegatron – mass production hasn’t started yet, but that’s not far off as Apple is aiming for a launch in September (or October if there are significant delays).
Source 1| Source 2| Source 3 (in Chinese) | Via 1 | Via 2